Traverse Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
More questions for those in the know.....The manual says that once the brake controller is installed (just did that) wires under/in the fuse box (under hood) need to be hooked up. Has anyone done this as my brake controller right now is dead. If you have is it easy or is it something the dealer/garage needs to do.

Thanks
 

·
Registered
Joined
·
3 Posts
I have installed a Tekonsha Prodigy brake controller on my Traverse a week ago with the adapter from Tekonsha (part number 3026-P)

The toughest part was to gain access to the vehicule connector that is located near the parking brake pedal, under the dash. Since I didn't had the tool to remove the screws that were keeping the panel in place, I had to slip my hand in a small hole to grap the connector and attach the adapter to it.

I have installed the controller and attached the other end of the adapter to it and it worked. I have connected the cable from my trailer and tested everything OK.

I hope this little information will help you.

Daniel.
 
1 - 2 of 2 Posts
Top