Search Results for ‘traction control light’

I bought this Traverse 2 months ago. I had to get the air conditioner fixed. After I picked it up from the mechanic, I found that both my front blinkers aren’t working. A couple days ago I heard the ding ding ding, and message was traction control off/service stabilitrak. Today I had a low tire...

Yesterday my car started and ran fine. Today it cranks but won't start. The check engine light is on and dash says service stabilitrak, traction control off and engine power reduced. Code reader shows no codes. We cleaned the throttle body and disconnected battery for 20 mins.and it did not...

Hi. I just found this forum and I'm hoping to find help. I have a 2017 Traverse with around 54k miles. In March the check engine light started popping on and the car was rough idling, I could smell gas occasionally when I stopped after being in stop and go traffic. I took it right away to a...

I bought my 2014 not even a year ago. It has under 100kmiles and I have already spent over $3000 for the same problem. The check engine light will come on, the car will start to shake and it will throttle a little. Traction control off and stabilitrak needs changing will pop up in my service...

So I'm on my way home and I hear a soft pop noise followed by a internal spinning sound. Couldn't really accelerate, lot of vibration, and my notifications screen displayed "Loss of power - Traction control off" somehow I made it home and turned the ignition off and tried to restart it, and...

This started in the middle of a snow storm and someone is insisting a sensor is plugged up and once Temps come back out of the teens it will melt out and be fine. Just curious on the validity of that... I have searched youtube and threads for days and I can't seem to find one that is having the...

Has anyone else had the problem where the light goes on for traction control and the stability display going across the dash plus you can’t-turn the traction back on from the button and if so does anyone know what that could be I reset the code because I replaced the mass air flow sensor and...